Watch how quick and easy it is to unpack and install the EZ2 Connect so it is ready for first use.

Reminder: It’s best to unpack the instrument near the workbench where you’re going to keep it. Check the user manual to make sure your workbench meets all requirements.

With the EZ2 Connect, you don’t need a lot of time or training to start a protocol run. It only takes a few simple steps to set up the workdeck.

Once your run begins, you can leave the lab and just wait for the notification on your phone once the run is finished.*

Then unload the workdeck and collect your high-quality nucleic acids. It really is that easy.

* Available if you enable QIAsphere on your instrument. QIAsphere is a free service. Learn more about QIAsphere at www.qiagen.com/qiasphere

Take a closer look at the EZ2 Connect’s intuitive and user-friendly touchscreen user interface.

See how it guides you step-by-step, all the way from instrument setup to regular maintenance.

Discover the different kinds of EZ2 Connect tip racks, including one that lets you process up to 8 ml of sample for greater sensitivity.

See also some of the kits you can use them with, including kits for FFPE samples, ccfDNA, and a kit for purifying DNA meant for downstream NGS.

Proper instrument maintenance keeps the quality and reliability of your experiments high despite multiple runs.

This video shows you how to perform maintenance procedures on your EZ2 Connect, to keep it in good working condition.